Delta DVP-14SS2Manual, data sheet and how to read its data
Two things on one page: where the official manufacturer documentation lives and, below, the integration sheet (where data comes out of this unit and which protocol it speaks), which the manual never sums up anywhere.
Official manufacturer documentation
We do not host third-party manuals: the right version is always the manufacturer's, who also updates the PDFs when the firmware changes. This link takes you to the Delta DVP-14SS2 document catalog.
Delta · download centerWhere the data comes out
- Built-in RS-232
- Programming port, also valid for Modbus reads.
- Built-in RS-485
- Second port, Modbus RTU or ASCII, as master or slave.
Parameter numbers and register maps change between firmware versions, so those belong in the manufacturer manual, not in this table. Always confirm the exact part number in your panel.
What you can read without rewiring the panel
The DVP-14SS2 has no Ethernet. It is read over serial Modbus and put on the network with a gateway.
- 1Identify the exact part number and firmware: within one family there are models with Ethernet and models with only a serial port.
- 2Write down the communication parameters already loaded (baud rate, parity, slave address). Changing them to experiment is what takes a production line down.
- 3Read in query mode, with the equipment running. iGromi only reads: it does not write to the device or change its parameters; if a value suggests an adjustment, a person decides.
- 4Store each value with its timestamp and context (shift, order, operator). A bare number will not tell you later why the machine stopped.
When the unit is not alone
Reading one DVP-14SS2 is a short job. The problem starts when the plant has fifteen units from six brands, each with its own protocol and wiring. The iGromi Bridge speaks Modbus RTU and TCP, OPC UA, BACnet, CANopen and MQTT on the same node, and when a unit's parameters are unknown it finds them by trying combinations until it communicates. Always read-only.
Safe industrial AI, starting free from the app.
The app gathers what your team knows: each trade with its helpers, and @igromi answers citing the source. AI reads, proposes and cites; a person decides. When you add systems and equipment, the Edge reads PLCs in read-only mode.
- AssetsPLCs, sensors, cameras, GPS
- SystemsSAP, ERP, MES, SCADA, spreadsheets
- PeopleOperators and managers: judgment and fixes
No credit card. Your data stays yours.
